Why is my Pentair Control Unit backwashing or purging at an excessively low or high rate?
If your Pentair Control Unit is backwashing or purging at an excessively low or high rate, it might be due to an incorrect drain control being used. Replace it with the correct size controller. Another cause could be foreign matter affecting valve operation; remove the drain control and clean the ball and seat.
What to do if my Pentair 760 controller has no water flow display when water is flowing?
If your Pentair 760 controller shows no water flow when water is flowing, first check if the bypass valve is in the bypass position and shift it to the non-bypass position. Also, the meter probe might be disconnected or not fully connected to the meter housing; fully insert the probe into the meter housing. Finally, restricted meter turbine rotation due to foreign matter in the meter could be the issue; remove the meter housing, free up the turbine, and flush with clean water. The turbine should spin freely; if not, replace the meter.
General| Model | Logix 762 |
|---|---|
| Category | Control Unit |
| Voltage | 24V AC |
| Display | LCD |
| Input Voltage | 24V AC |
| Output Voltage | 24V AC |
| Compatibility | Pentair automation systems |
| Operating Temperature | 32°F to 122°F |
| Storage Temperature | -4°F to 158°F |
| Humidity Range | 95% non-condensing |
| Dimensions | 3.5 inches |
| Weight | 2.5 lbs |
Details initial setup parameters like installation number, date, resin, and tank sizes.
Covers flow rates and component sizes for water treatment hydraulics.
Warns about potential dangers, personnel qualifications, and material handling.
Guides through initial setup of time, date, and day of the week.
Details how to initiate immediate or delayed regeneration cycles.
Instructs on gathering information for support and contacting the dealer for issues.
To Next Page
