26
P/N 38033 Rev. C 12-1-00
Troubleshooting
IGN RETURN (GRN)
WHT
PACFAB 6800
THERMOSTAT
ELECTRONIC
DUAL
THERMISTOR PROBE
ON / OFF / ON
SWITCH
(WHT)
SPA
(WHT)
POOL (WHT)
COMMON
WHT
WHT
WHT
THERMAL FUSE
ORN
WHT
RED
ORN
BLK
J BOX
GRN
ORN
WHT
RED
BLUE
WHT
BLUE
RED
CHASSIS SHEET METAL
TRANSFORMER
RED
WHT
PRESSURE
SWITCH
WHT
GAS VALVE
IID
RED
RED
RED
RED
WHT
IGNITION
MODULE
BLUE
GRN
HILIMITS
HI TENSION
WIRE
IID PILOT
WHT/BLK
WHT/RED
JUMPER
(WHT)
The wiring was crossed from
the Switch to the Board and
we used a Breaker (Reset)
that was external to the
Transformer.
POWER / T-STAT / AUX ONLY!
This list will suggest situations that might cause this symptom.
1. Pump “OFF” - switch Pump on and make sure it primes.
2. Pump too small or worn out - minimum 30 G.P.M. to cause Pressure Switch to close.
(Some 2-speeds will not produce 30 G.P.M., on low speed.)
3. Filter dirty - backwash or clean filter.
4. Incorrect wiring - check Schematic and wire connections.
5. Defective Pressure Switch or something blocking the flow to the switch - bypass Pressure Switch
and or check fitting opening for debris.
To Next Page
Loading...
