Pentair MiniMax Plus - Millivolt Wiring Diagram

34
P/N 38033 Rev. C 12-1-00
MiniMax Millivolt Wiring
WHT
GAS VALVE
ORN
WHT
HI-LIMIT
OFF
SPA
WHT
WHT
SHUT-OFF
SAFETY
SWITCH
PRESS
WHT
POOL
       
PILOT
GENERATOR
THERMAL
CUT-OFF
TH
PP
TH/PP
POT 1
THERMOSTAT BOARD
POT 2
TH/PP
PP
POT
SENSOR
SEN
TH
WHT
IF ORIGINAL FACTORY WIRING MUST BE REPLACED, INSTALLER MUST SUPPLY UL OR CSA (IF CANADA) APPROVED
WIRE, 18 GAUGE, 600V, 105 C˚ TEMPERATURE RATING. THERMAL FUSE WIRING MUST BE REPLACED WITH UL OR CSA (IF CANADA)
APPROVED WIRE, 18 GAUGE, 600V, 125 C˚ TEMPERATURE RATING. INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM
TO THE NATIONAL ELECTRICAL CODE OR SUPERCEDING LOCAL (WIRING) CODES.
WHT
RED
MiniMax Millivolt Wiring
AFTER 1-15-01
BEFORE 1-15-01
MINIMAX WIRING DIAGRAM (MILLIVOLT) DUAL THERM
ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THIS HEATER MUST BE REPLACED.
INSTALLER MUST SUPPLY (NO. 18 AWG 105˚ C U.L. & C.S.A. FOR CANADA) COPPER WIRE.
LEGEND: WHT: WHITE
WHTWHT
ORN
OFF
CONTROL
POOL TEMP
ORN
CONTROL
SPA TEMP
ORN
GAS VALVE
GENERATOR
PILOT
HI-LIMIT
WHT
SAFETY
SHUT-OFF
CUT-OFF
THERMAL
POOL ON
SPA ON
WHT
ORN: ORANGE
WHT
PRESS
SWITCH