PROWLER P10 & P20 Robotic Inground Pool Cleaner Installation and User’s Guide
English
8
Problem Possible Cause Corrective Action
CLEANER DOES NOT
TURN ON
There is no electricity in the wall
socket:
(1) Disconnect cleaner from the power and
control unit. (2) Disconnect power supply
from the wall socket, wait 30 seconds and
reconnect. (3) Turn power on. If not activated,
connect the unit to a different wall socket.
Obstacle in the drive system of the
cleaner unit:
(1) Turn the cleaner unit carefully to view the
bottom side. (2) Check that the scrubbing brush
is not bent/broken. (3)Clean and remove obsta-
cles and debris if necessary.
Propeller is seized due to accumula-
tion of hair:
Check if the propeller is broken or needs to be
cleaned (see “Checking Water Outlet Propeller”).
CLEANER MOVES
BUT DOES NOT PUMP
WATER
Filters are dirty: (1) Remove the lters and clean them.
Propeller is broken or seized due to
accumulation of hair:
Check if the propeller is broken or needs clean-
ing (see “Checking Water Outlet Propeller”).
CLEANER PUMPS
WATER BUT DOES NOT
MOVE
Obstacle in the drive system of the
cleaner unit:
(1) Turn the cleaner unit carefully to view
the bottom side. (2) Check that the scrub-
bing brush is not bent/broken. (3) Clean and
remove obstacles and debris if necessary.
CLEANER STARTS
AND SHUTS OFF
AFTER A SHORT TIME
Filters are dirty: (1) Remove and clean the lters. (2) Restart
the robot and try again.
Propeller is broken or seized due to
accumulation of hair:
(1) Remove the top screws on the top outlet.
(2) Check if the propeller is broken or needs to
be cleaned.
Obstacle in the drive system of the
cleaner unit:
(1) Turn the cleaner unit carefully to view
the bottom side. (2) Check that the scrub-
bing brush is not bent/broken. (3) Clean and
remove obstacles and debris if necessary.
CLEANER DOES NOT
PICK UP DIRT
Filters are dirty or have holes: Clean as needed and verify that there are no
holes in the lters.
Propeller is broken or seized due to
accumulation of hair:
Check if the propeller is broken or needs clean-
ing (see “Checking Water Outlet Propeller”).
CLEANER UNIT DOES
NOT COVER THE
ENTIRE POOL
Floating cable is to short: (1) Verify that there is enough length of the oating
cable in the water to reach the far end of the pool.
(2) Make sure that the oating cable is properly
spread out and is not tangled.
Propeller is broken or seized due to
accumulation of hair:
(1) Remove the top screws on the top outlet.
(2) Check if the propeller is broken or needs
cleaning.
THE CLEANER DOES
NOT CLIMB WALLS
(1) Verify that your robotic cleaner is not a
oor-only model. (2) Verify that Program 1,
oor cleaning only, is not selected on the
power supply unit. (3) Make sure to clean the
lters (4) Make sure propeller isn’t broken or
tied up to debris/hair.
TROUBLESHOOTING
To Next Page
Loading...
