PROWLER P10 & P20 Robotic Inground Pool Cleaner Installation and User’s Guide
EnglishEnglish
5
Cleaning the lter(s)
The two lter(s) must be cleaned after each cleaning cycle. Press the button to release the lter and pull it out of
the cleaner. Open the lter case. Spray water on the outer sides of the lter and then spray water towards the inner
side of the lter to clean all the dirt and debris. Reinsert the lter back into its location.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in use: Disconnect the power cord from the wall
outlet. Disconnect the oating cable from the power supply. Make sure that the power supply is not exposed to
water Spread out the oating cable, and roll it. Wash the cleaner unit interior space with fresh water and let it dry.
Roll the oating cable and place it on the cleaner unit. Caution: Do not roll the oating cable on the handle of the
cleaner unit. Store the robotic cleaner components in a dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the propeller of the water outlet: Remove the lter(s).
Remove the screws that hold the water outlet cover. Remove the water outlet cover. Clean any hairs, dirt, or debris.
Return the cover and fasten it with the screw. Reinsert the lter(s).
For warranty conditions and spare parts view, please check www.pentairpooleurope.com
MAINTENANCE AND STORAGE
1
4 5
2 3
To Next Page
Loading...
