79
And press [ENT] to view the STATION POINT SETUP
screen.
Press the [ENT] to view the AIM AT THE REFERENCE
POINT screen.
Aim at the previous station, then press [ENT].
The direction angle is set automatically.
It proceeds to MEASURE screen automatically.
Measuring
Aim at the Target point and press [F1][MEAS] to measure the distance.
Press [F3][ME/SAVE] to measure and save the measured data as sideshot point.
Press [F2][SAVE] to save the measured data as sideshot point.
Press [F4][EDIT] to edit the PN, Point Name, PH, Prism Height and PC, Point Code. Press [ENT] to
view the each input window by pressing the up or down arrow key, and input your desired point
name or prism height or point code. Press the [F5][ACCEPT], if the current PN, PH and PC are
acceptable.
Press the [ENT] to save the measured data as corner point
If [ENT] is pushed more than twice at the one station, the last [ENT] point becomes next corner point.
Note
Please use [SAVE] [ME/SAVE] and [ENT] properly by sideshot and corner point.
Press [F5][PAGE] to view another menu.
To finish the traverse measurement
Fixed traverse
Please measure the known point and press [ENT] at the last corner point.
To Next Page
Loading...
Need help?
General
