38
8. INITIAL SETTING
8.1 Overview
For the R-200 series, you can select and save the desired setting for a variety of prescribed
instrument conditions, called initial setting.
The Initial Setting is saved in four modes, “initial setting 1”, “initial setting 2”,, “initial setting
4”, and “initial setting 5” in which you can select and save the instrument conditions
described below.
The factory default for each of these conditions is marked by .
To change initial setting, follow the operating procedures for entering each initial setting
mode in “8.2” and the operating procedures for changing an initial setting in “8.2”.
8.2 Entering the mode for initial setting 1
Press the [POWER] key while holding [F1] key
down to access the screen for initial setting 1.
• Pressing [F1] [ △ ] scrolls it up five items; pressing [F2] [ ▽ ] scrolls the screen down five
items.
• Press [F3] [ ] or [F4] [ ] to position
the cursor at the item of interest.
8.3 Entering the mode for initial setting 2
Press the [POWER] key while holding [F2] key
down to access the screen for initial setting 2.
• Select the item of interest in the same way as
in the mode for initial setting 2.
8.4 Entering the mode for initial setting 4
Press the [POWER] key while holding [F4] key
down to access the screen for initial setting 4.
• Select the item of interest in the same way as
in the mode for initial setting 4.
8.5 Entering the mode for initial setting 5
Press the [POWER] key while holding [F5] key
down to access the screen for initial setting 5.
1.ATM CORR ：ATM INPUT
2.PRISM CONST ：-30mm
3.SHEET CONST ： 0mm
4.CRV/REF CORR ：0.14
1.ATM CORR ：ATM INPUT
2.PRISM CONST ：-30mm
3.SHEET CONST ：0mm
4.CRV/REF CORR ：0.14
To Next Page
Loading...
Need help?
General
