Need help?Do you have a question about the peoplenet PD5 and is the answer not in the manual?
General| Brand | peoplenet |
|---|---|
| Model | PD5 |
| Category | Automobile Accessories |
| Language | English |
Details the PD5 Display unit, part number L-019-0516.
Lists the PD5 Fixed Mount Kit, part number M-010-0634.
Specifies the PD5 Cable, part number L-016-0642.
Identifies the RAM Mount, part number H-050-0013.
Lists the available Screw Packs for installation.
Details the intended use of the PD5 device, emphasizing mounted operation within a truck-cab.
Diagram shows PD5 Display Cable L-016-0642 connection.
Diagram shows PMG Standard Cable L-016-0590 or Auxiliary Cable L-016-0562.
Diagram shows PMG J1939 2 Pin Main Cable L-016-0561.
Diagram shows Fused Power Assembly Cable L-016-0556 connection.
Diagram shows Internal Cell/GPS/WiFi Antenna H-055-0506.
Component identification for the PD5 Display in a PCG system.
Diagram shows Display Cable L-016-0642 connection.
Diagram shows PCG Main Cable L-016-0631 connection.
Diagram shows PeopleNet Connected Gateway E-006-0567.
Guidance on selecting a suitable, sturdy, and accessible dash location for the PD5 mount.
Instructions for mounting the RAM base to the vehicle and the display unit.
Steps for connecting the PD5 cable to the display and routing it safely behind the dash.
Procedure for connecting the blue barrel connector for module communication and triggers.
Details on connecting the power and ground to the display via the power assembly.
Instructions for powering on the vehicle and confirming the PD5 device boots correctly.
Guidance on the subsequent steps for pairing and initializing the installed device.
Steps to access settings by swiping lock screen and selecting the app menu.
Selecting 'Settings' then 'Apps' to manage default applications.
Selecting the gear icon to configure app settings and choosing the home app.
Selecting 'PMobile' as the default home application for automatic startup.
Using the home key to launch the PMobile application after setting it as default.
Inputting the administrator password '9238' to start the installation process.
Inputting the OBC's serial number for device identification and pairing.
The PD5 attempts Wi-Fi connection to the OBC DSN for setup.
The PD5 may need to modify a setting to communicate properly with the OBC.
Prompted to re-enter the OBC's DSN after a reboot to complete installation.
The PD5 retries the Wi-Fi connection to the OBC after re-entering the DSN.
Inputting Installer ID and Password for PCG/PD5 pairing and trust establishment.
Guidance on resolving issues if installation credentials are not accepted or cause errors.
Answering 'yes' or 'no' to whether this is a new installation based on OBC state.
Inputting Installer ID and Vehicle Number for new truck setups.
Inputting details for existing truck setups or swapping modules.
Submitting the installation request and observing the process status.
Steps to resolve error codes during installation, checking truck number and DSN.
Confirmation that the installation request was accepted by PFM and is proceeding.
The PD5 loads settings from PFM, with services showing 'Activating' then 'Activated'.
The PMobile software reboots to complete the installation.
Checking GPS status (3D) and cell signal strength (>2) in OBC diagnostics.
Confirming ignition status, RPM, and odometer readings in diagnostics.
Checking the display power button LED for charging (Green) and battery status (Blue).
Confirming activation of any connected accessories like Satellite, OBDii, GPIO, PTO.
Instructions on how to find and use the hard reboot button on the device.
Diagram showing the pin configuration for the PD5 Cable L-016-0642 mating connector.
Identifies vehicle power (Pin 8) and ground (Pin 7) connections for the PD5 cable.
Identifies OBC power (Pin 6) and ground (Pin 3) connections for the PD5 cable.
States FCC Part 15 compliance conditions regarding interference.
Highlights cautions regarding unauthorized modifications and transmitter co-location.
Details FCC limits for radiation exposure and minimum installation distance.
To Next Page