PepVPN Profiles
to Bridge
The remote network of the selected PepVPN profiles will be bridged with this local
LAN, creating a Layer 2 PepVPN, they will be connected and operate like a single
LAN, and any broadcast or multicast packets will be sent over the VPN.
Enable this option if you want to block network traffic between the remote
networks, this will not affect the connectivity between them and this local LAN.
Click the box will enable STP for this layer 2 profile bridge.
Override IP
Address when
bridge
connected
Select "Do not override" if the LAN IP address and local DHCP server should
remain unchanged after the Layer 2 PepVPN is up.
If you choose to override the IP address when the VPN is connected, the device
will not act as a router, and most Layer 3 routing functions will cease to work.
Click on the question Mark if you want to enable DHCP Option 82.
This allows the device to inject Option 82 with Router Name information before
forwarding the DHCP Request packet to a PepVPN peer, such that the DHCP
Server can identify where the request originates from.
To Next Page
Loading...
