peplink PEPWAVE HD Dome Pro - Page 41

- The LED indicators of Wi-Fi 1 & 2 shown as below is referring to the default settings of
Wi-Fi Operation mode is WAN + AP under the AP. For more details, please refer to the
section 25.4
2.17.2 LED Indicators
The statuses indicated by the front panel LEDs are as follows:
Status Indicators
Status
OFF
System initializing
Red
Booting up or busy
Blinking red
Boot up error
Green
Ready
Wi-Fi WAN Indicators
Wi-Fi 1
OFF
Disabled Intermittent
Blinking slowly
Connecting to network(s)
Blinking
Connected to network(s) with traffic
ON
Connected to network(s) without traffic
Wi-Fi AP Indicators
Wi-Fi 2
OFF
WiFi AP is disabled.
ON
WiFi AP is enabled.
Cellular Indicators
Cellular 1 / 2 /
3 / 4
OFF
Disabled or no SIM card inserted
Blinking slowly
Connecting to network(s)
Green
Connected to network(s)
LAN and Ethernet WAN Ports
Green LED
ON
10 / 100 / 1000 Mbps
Orange LED
Blinking
Data is transferring
OFF
No data is being transferred or port is not connected
Port Type
Auto MDI/MDI-X ports
https://www.peplink.com
41
Copyright @ 2021 Peplink