SLG2008A
Owner’s Manual
10
Step 7
a) Align the holes on side knob seat (RR) with the holes
on the right side shelf and side burner valve. Screw
one M4x16mm bolt (F) and one small washer (G)
into each pre-drilled hole.
b) Tighten the bolts using the screwdriver provided.
Insert the side burner knob (QQ) into knob shaft of
valve.
Step 8
a) Open the side burner lid and place the side
burner assembly (JJ) on the right side shelf.
Make certain the venturi tube is connected
properly with valve.
b) Align the holes on the side burner assembly with
the holes on the right side shelf.
c) Insert one M4x12mm bolt (F) and one small
washer (G) into each pre-drilled hole.
d) Screw one M4 nut (H) into each bolt by hand.
c) Go back to tighten all the bolts using screwdriver
provided.
To Next Page
Loading...
