2 Instructions for Assembly and Use – Standard Configuration
MULTIPROP Slab Props
Introduction
Area of application
MULTIPROP Slab Props
– are props made of aluminium,
– correspond to the load requirements
of DIN EN 1065,
– are used as vertical supports for tem-
porary constructions.
Standard configuration
Intended use
1. PERI products have been designed
for exclusive use in the industrial and
commercial sectors by suitably trained
personnel only.
2. These Instructions for Assembly and
Use serve as basis for the project-relat-
ed risk assessment and the instructions
for the provision and use of the system
by the contractor (user). However, they
do not replace them.
3. Only PERI original components may
be used. The use of other products and
spare parts represents a misapplication
with associated safety risks.
4. The components are to be inspected
before each use to ensure that they are
in perfect condition and function cor-
rectly.
5. Changes to PERI components are
not permitted and represent a misappli-
cation with associated safety risks.
6. Safety instructions and permissible
loads must be observed at all times.
7. Components provided by the contrac-
tor must correspond to the characteris-
tic features required in these Instruc-
tions for Assembly and Use as well as
all current laws and standards.
In particular, the following applies if
nothing else is specified:
– timber components: Strength Class
C24 for Solid Wood EN 338.
– scaffold tubes: galvanised steel tubes
with minimum dimensions of Ø 48.3
x 3.2 mm according to EN 12811-
1:2003 4.2.1.2.
– scaffold tube couplings according to
EN 74.
8. Deviations from the standard config-
uration may only be carried out after a
separate risk assessment has been
completed by the contractor (user).
On this basis, appropriate measures for
the working safety and stability are to
be implemented.
Main components
MULTIPROP
MP 120, L = 0.80 – 1.20 m
MP 250, L = 1.45 – 2.50 m
MP 350, L = 1.95 – 3.50 m
MP 480, L = 2.60 – 4.80 m
MP 625, L = 4.30 – 6.25 m
System dimensions
Assembly heights as individual props
according to the permissible extension
lengths 0.80 m – 6.25 m or 1.30 m –
6.75 m for use with Base MP 50.
Technical data
– Approval Z-8.312-824.
– For load-bearing capacities,
see Tables.
Features
MULTIPROP slab props are used in
shoring operations in a planned perpen-
dicular position for the transfer of verti-
cal loads. In particular, they also provide
support for slab formwork systems.
The outer tubes of the MULTIPROP
Slab Props are powder coated.
The integrated measuring tape and
free-running collar allow accurate and
fast height adjustment.
The height is continuously adjustable
by means of the end-to-end thread
without pegging. The MULTIPROP Slab
Prop has a fail-safe feature which pre-
vents the inner tube from unintentional-
ly slipping out.
EX_AuV_MULTIPROP_MP_Deckenstutzen.indb 2 24.03.16 15:10
To Next Page
Loading...
