PerkinElmer CLARUS 680 GC User Manual

Clarus 600/680 GC User’s Guide
2-9
When the GC is ready, touch the Start button to begin the run. If you touch Start
before the system is ready, the run will start when the system reaches the ready
status.
When the Autosampler is disabled, touching the Run button displays the Manual
inject screen. When the instrument is ready, touch the Start button to begin the
analysis. The countdown enable check box is selected by default. You can stop
the countdown by pressing the Cancel button.
Manual Injection
If no Autosampler is installed or configured, the Run button displays the Manual
injection screen.
The enable check box is selected by default. Touching the start button initiates
the countdown starting from 5 seconds. When the countdown reaches 0, an
audible beep prompts you to inject the sample. The GC will then start to program
the oven and collect data. If the enable check box is deselected, the timer and
tone are disabled. The system starts as soon as the Start Button is pressed and you
make an injection simultaneously.

PerkinElmer CLARUS 680 GC Specifications

General

Brand	PerkinElmer
Model	CLARUS 680 GC
Category	Laboratory Equipment
Language	English