24. Lambda 265, 365 and 465 ASX-260 AND ASX-520 Autosampler Users Guide
Installation
1. Place the Lambda 265/365/465 autosampler (ASX-260/280 or 520/560) and
peristaltic pump in a location that is compatible with the required environmental
conditions for the operation.
2. Connect the communication cable and the power cord to each system and PC.
3. When the autosampler is connected via USB, the customer needs to install in the
PC the USB driver enclosed in the Install CD.
4. In case of peristaltic pump you should download the USB driver on the IDEX
website.
5. website: https://www.idex-hs.com/support/literature-downloads/software-and-
drivers.
NOTE:
In case of using laptop computer, the converter (RS-232 to USB) is not recommended
since the laptop is very sensitive to the noise resulted from the unstable electric power
supply. If the converter should be used, the electric power of laptop should be supplied
from AC power, not from battery.
6. Connect a flow cell to the tube line between the peristaltic pump and the
autosampler.
NOTE: In case of autosampler installation, refer to Autosmapler manual.
To Next Page
Loading...
Need help?
General
