Need help?Do you have a question about the PerkinElmer Lambda XLS and is the answer not in the manual?
General| Type | UV/Vis Spectrophotometer |
|---|---|
| Wavelength Range | 190 - 1100 nm |
| Light Source | Deuterium and Tungsten Halogen lamps |
| Detector | Silicon Photodiode |
| Power Requirements | 100-240 V, 50/60 Hz |
| Spectral Bandwidth | 2 nm |
| Wavelength Accuracy | ±0.5 nm |
| Photometric Repeatability | ±0.002 A at 1 A |
| Stray Light | <0.05% at 220 nm and 340 nm |
| Data Interval | 0.2 nm, 0.5 nm, 1.0 nm, 2.0 nm, 5.0 nm |
| Baseline Flatness | ±0.002 A |
| Sample Compartment | Standard 10 mm path length cuvettes |
| Data Output | USB, RS-232 |
| Baseline Stability | ±0.001 A/h |
Details safety standards, directives, and general precautions for the Lambda Bio/XLS instruments.
Details on connecting the instrument to the appropriate line power supply for safe operation.
Explains how to navigate the instrument's software interface and configure method parameters.
Details on accessing utilities to configure date, time, regional settings, printer, and display preferences.
Step-by-step guide for performing single wavelength absorbance and transmission measurements.
Procedures for collecting and analyzing absorption spectra, including peak detection and scaling.
How to perform concentration measurements using predefined factors or by measuring standards.
Guide to creating multi-point calibration curves for quantifying unknown sample concentrations.
Steps for performing time-dependent absorbance studies and calculating reaction rates.
To Next Page