Accessories . 73
Printer Installation and Configuration
The Printer Accessory (L7110230) is an optional accessory that allows you to print your data
as you run your samples, directly from your instrument.
Printer installation
1. Turn off the line power supply and disconnect the power cable.
2. Turn the instrument over and remove the two cap head screws using the 3 mm
hexagonal wrench provided.
3. Turn the instrument back over and lift the accessory cover vertically upwards to
remove. Remove the tie-wrap from the cable.
4. Invert the instrument and replace the cap head screws.
To Next Page
Loading...
