PerkinElmer FL 6500 User Manual

09931519A
PerkinElmer, 710 Bridgeport Avenue,
Shelton, CT 06484-4794, U.S.A
Produced in the USA.
FL 6500/8500 Single Cell Peltier Holder
Installation Instructions
This instruction sheet describes the installation of this accessory which is used with the FL 6500/8500
Fluorescence Spectrometer.
NOTE:
Read these instructions before you install this accessory.
Contacting PerkinElmer
Supplies, replacement parts, and accessories can be ordered directly from PerkinElmer, using the part
numbers.
See our website:
http://perkinelmer.com
PerkinElmer's catalog service offers a full selection of high-quality supplies.
To place an order for supplies and many replacement parts, request a free catalog, or ask for information:
If you are located within the U.S., call toll free 1-800-762-4000, 8 a.m. to 8 p.m. EST. Your order will be
shipped promptly, usually within 24 hours.
If you are located outside of the U.S., call your local PerkinElmer sales or service office.
Features
• Full software control
• Liquid cooling system
• N
2
gas purging available
Figure 1 Single Cell Peltier Holder [P/N: N4201029]

PerkinElmer FL 6500 Specifications

General

Brand	PerkinElmer
Model	FL 6500
Category	Measuring Instruments
Language	English

Summary

FL 6500/8500 Single Cell Peltier Holder Installation Instructions

Contacting PerkinElmer

Information on how to order supplies, replacement parts, and accessories from PerkinElmer.

Features of the Peltier Holder

Highlights the main capabilities of the Peltier Holder, including software control and cooling systems.

Product Specifications

Peltier Temperature Controller 201 Specifications

Technical specifications for the Peltier Temperature Controller 201, including power, range, and dimensions.

Single Cell Peltier Holder Specifications

Technical specifications for the Single Cell Peltier Holder, including sample cells, dimensions, and accuracy.

Safety Warnings

General Safety Precautions

Explains warning labels and general safety precautions to prevent electrical shock and ensure safe operation.

Component Configuration

Single Cell Peltier Holder Diagram

Illustrates the Single Cell Peltier Holder with labels for key components and connections.

Peltier Temperature Controller 201 Views

Front View Components

Details the front panel of the Peltier Temperature Controller 201, including display, buttons, and indicators.

Peltier Temperature Controller 201 Rear View

Rear View Components and Notes

Details the rear panel of the Peltier Temperature Controller 201, including ports, vents, and fuse.

Coolant Handling Procedures

How to Fill the Coolant

Step-by-step instructions for filling the Peltier Temperature Controller 201 with liquid coolant.

How to Drain the Coolant

Installation

Accessory Installation Steps

Provides initial steps for installing the Single Cell Peltier Holder accessory onto the instrument.

Setting USB Serial Port

Measurement

Software Measurement Configuration

Guides users through setting up measurement parameters within the Spectrum FL software.

Temperature Modes

Constant Mode Operation

Explains how to use Constant mode for temperature control during measurements.

Ramp Mode Operation

Auto Tuning Setup

Peltier Temperature Controller 201 Auto Tuning

Steps to perform auto tuning on the Peltier Temperature Controller 201 for optimal performance.

Troubleshooting

Power LED Issues

Addresses issues where the power LED is not lit on and provides solutions.

Fan and Sensor Alarm Issues

Solutions for fan alarms and blinking LEDs for LOW LEVEL, FLOW SENSOR, and PUMP.

Connection Failure

Guidance on resolving connection failures between the controller and other components.