Installing your Instrument . 17
Connecting to the Line Power Supply
WARNING
To prevent potential injury to yourself and damage to the instrument,
make any electrical connections in the system before connecting to the
line power supply.
The instrument automatically adjusts to the correct operating voltage.
Connect to the supply outlet with power supply provided and the power cord that is
appropriate for your region.
You must use the power cord and power supply supplied with the instrument.
NOTE: If the instrument has just been unpacked or has been stored in a cold environment,
it should be allowed to come to thermal equilibrium in the laboratory for 2–3 hours
before turning the instrument on. This will prevent calibration failure as a result of
internal condensation.
Figure 1 Rear connections on the Lambda Bio/XLS instrument
The ON/OFF switch is located at the top left-hand of the keypad panel.
To Next Page
Loading...
Need help?
General
