PerkinElmer LAMBDA 265 User Manual

Installation 31
6. Remove the two Phillips round head screws with washer (M4*12L) to disassemble
the existing cell holder and base plate. And then insert the front plate for Auto
Sipper accessory in the sample compartment.
7. Tighten the front plate for Auto sipper accessory in the sample compartment with
the screws and insert the single cell holder on the front plate and tight the knob.

PerkinElmer LAMBDA 265 Specifications

General

Brand	PerkinElmer
Model	LAMBDA 265
Category	Measuring Instruments
Language	English