Warnings and Safety Information . 15
Electrical Safety
Connect the microscope to a power supply line that includes a switch or other adequate
means of disconnection from the electricity supply.
Plug the microscope into electricity-supply sockets that are provided with a protective ground
(earth) connection only. The microscope must be earthed.
If fuses need replacing, use only those with the required current rating and of the specified
type. Do not use makeshift fuses and do not short-circuit fuse holders.
When the microscope is connected to its electricity supply, terminals may be live. Removing
covers other than those which can be removed by hand is likely to expose live parts.
NOTE: There are no user-serviceable parts in the microscope.
Capacitors inside the microscope may still be charged even if the microscope has been
disconnected from all voltage sources.
Disconnect the microscope from all voltage sources before opening for any adjustment,
replacement, maintenance or repair. Any adjustment, replacement, maintenance or repair
must be performed by a PerkinElmer Service Representative.
The microscope must only be connected to equipment meeting the requirements of
IEC 61010-1 (Safety requirements for electrical equipment for measurement, control and
laboratory use – general requirements) or IEC 60950 (Safety of information technology
equipment).
WARNING
Any interruption of the protective ground (earth) conductor inside or
outside the microscope
or disconnection of the protective ground (earth)
terminal can make the microscope dangerous.
To Next Page
Loading...
Need help?
General
