(Table 3, contd)
Throttle Position 2 Engine Speed
Throttle Position 3 Engine Speed
Throttle Position 4 Engine Speed
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Status
Throttle Lock Feature Installation Status
Multi State Input Switch Enable Status
Multi State Input Switch Control Purpose
Multi Position Throttle Switch Initialization Enable Status
Throttle Lock Engine Set Speed #1
Throttle Lock Increment Speed Ramp Rate
Throttle Lock Decrement Speed Ramp Rate
Throttle Lock Engine Set Speed Increment
Monitoring Mode Shutdowns
Limp Home Desired Engine Speed
Engine Acceleration Rate
Engine Location
High Exhaust System Temperature Indicator Installation Status
DPF Regeneration Inhibit Indicator Installation Status
DPF Soot Loading Indicator Installation Status
Oil Pressure Lamp Installation Status
Wait to Start Lamp Installation Status
Warning Lamp Installation Status
Shutdown Lamp Installation Status
Starter Relay Installation Status
Low Pressure Fuel Pump Installation Status
Remote Torque Speed Control Enable Status
Throttle Arbitration Method
Manual Throttle Arbitration Precondition Check
Throttle Enable Status
Throttle #1 Initial Lower Position
Throttle #1 Initial Upper Position
Throttle #1Idle Validation Switch Enable Status
Throttle #1Idle Validation Minimum Off Threshold
Throttle #1 Idle Validation Maximum On Threshold
Throttle #1 Lower Diagnostic Limit
Throttle #1 Upper Diagnostic Limit
(continued)
SEBU8726 51
Engine Diagnostics
Configuration Parameters
To Next Page
Loading...
