EasyManuals Logo

Perkins 854F-E34T Service Manual

Perkins 854F-E34T
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
4. Start and run the engine at low idle until the
temperature reaches 49 to 66 °C (120 to 150 °F).
5. Stop the engine and allow the engine to cool.
Loosen the cooling system filler cap slowly in order
to relieve any pressure. Remove the cooling
system filler cap. Remove the drain plug on the
engine. Open the drain cock or remove the drain
plug on the radiator. Allow the water to drain. Flush
the cooling system with clean water.
Fill
1. Install the drain plug on the engine. Close the drain
cock or install the drain plug on the radiator.
NOTICE
Do not fill the cooling system faster than 5 L
(1.3 US gal) per minute, in order to avoid air locks.
Cooling system air locks may result in engine
damage.
2. Fill the cooling system with Extended Life Coolant
(ELC). Refer to the Operation and Maintenance
Manual, “Fluid Recommendations” topic
(Maintenance Section) for more information on
cooling system specifications. Do not install the
cooling system filler cap.
3. Start and run the engine at low idle. Increase the
engine rpm to high idle. Operate the engine in
order to open the engine thermostat. This
procedure will allow any air in the system to be
purged. Decrease the engine speed to low idle.
Stop the engine.
4. Maintain the coolant level at the maximum mark
that is correct for your application.
Illustration 49 g02590196
Filler cap
5. Clean the cooling system filler cap and inspect the
gasket. If the gasket is damaged, discard the old
filler cap and install a new filler cap. If the gasket is
not damaged, use a suitable pressurizing pump in
order to pressure test the filler cap. The correct
pressure is stamped on the face of the filler cap. If
the filler cap does not retain the correct pressure,
install a new filler cap.
6. Start the engine. Inspect the cooling system for
leaks and for correct operating temperature.
i05197396
Coolant Extender (ELC) - Add
In order for Perkins ELC to achieve 12000 hours an
extender must be added at 6000 hours. For a suitable
extender, contact your Perkins dealer or Perkins
distributor.
90 SEBU8726
Maintenance Recommendations
Coolant Extender (ELC) - Add

Table of Contents

Other manuals for Perkins 854F-E34T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Perkins 854F-E34T and is the answer not in the manual?

Perkins 854F-E34T Specifications

General IconGeneral
BrandPerkins
Model854F-E34T
CategoryEngine
LanguageEnglish

Related product manuals