5
38 User’s Handbook, TPD 1285E, Issue 2
3.152
Lubricating oil specification
Use only a good quality lubricating oil to the relevant specification as shown in the table below.
(1) Not recommended for the first 25/50 hours of operation, nor for light load applications.
Warning! The type of lubricating oil to be used may be affected by the quality of the fuel which is available.
For further details see "Fuel specification" on page 37.
Always ensure that the correct viscosity grade of lubricating oil is used for the ambient temperature range in
which the engine will run as shown in the chart below (A).
Viscosity chart
A = Recommended viscosity grades
B = Ambient temperature
Engine type
Specifications
API CC
API CD
(1)
ACEA E1
(1)
Naturally aspirated
zz
Naturally aspirated engines in heavy duty earth moving equipment
z
Turbocharged
z
A
-30 -20 -10 0 10 20 30 40 50 ° C
-22 -4 14 32 50 68 86 104 122 ° F
0W
5W20
10W30
20
30
40
15W40
20W50
B
A
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
