Inspections and Maintenance
100
POWER STEERING FLUID LEVEL
1. Tilt the cab.
2. Clean the dipstick and its immediate surroundings to prevent any dirt from
entering the reservoir.
3. Check the fluid level in the reservoir using the dipstick.
4. The fluid level must be between the two marks.
5. Top up oil, if necessary, via the filler opening. Oil type: see "TECHNICAL
DATA".
6. If the level is below the minimum mark, this is a sign of leakage. Contact an
authorized Service dealer as soon as possible.
BRAKE SYSTEM AIR DRIER
The air drier can be checked for correct operation by inspecting the air reservoirs for
condensed water.
1. Check the air reservoirs for condensed water by pulling on the rings of the drain
valves.
2. If repeatedly more than the normal amount of water is drained off, the air drier
element will have to be replaced. Consult your Service dealer.
To Next Page
Loading...
