PART 8: MAINTENANCE AND SERVICE
PB1319 (CAT. NO. 5296 ) —137— 22-01691 (R02/02)
Crisscross Sequence For Demountable Rims
WARNING! Use only components marketed by
PACCAR Parts. Use of non–original equipment could
cause wheel breakage and wheel separation from vehi-
cle. Each mounting system is engineered only for use
with its correct mating part. Be sure that properly
matched components are used for each type of mount-
ing. The comparison chart on page 135 illustrates the
differences between parts used in hub–piloted mount
and ball seat mount applications. Only PACCAR Parts
supplied hub–piloted or ball–seat mounted wheels may
be used on this vehicle.
•
If you are not fully qualified and not equipped with the
proper tools and equipment, do not attempt to raise
the vehicle or remove or install the damaged tire and
wheel assembly. Obtain expert help. A person can be
seriously injured and/or damage can result from using
the wrong service methods. Truck tires and wheels
should be serviced only by trained personnel using
proper equipment. Do not reinflate a tire that has been
run flat or is seriously low on air without first removing
the tire from the rim and inspecting for damage.
•
Follow OSHA regulations per section 1910.177.
•
Do not exceed the speed rating of tires. Exceeding the
speed rating may result in sudden tire failure and loss
of vehicle control.
•
Follow all warnings and cautions contained within the
tire and wheel manufacturers literature.
•
Only properly trained personnel should service tire
and rim assemblies
02951
To Next Page
Loading...
