petMAP PETMAP+ II - Maintenance; Device Cleaning Instructions; Accessory Cleaning; Battery Replacement Procedure

46
MAINTENANCE
Device.
Cleaning petMAP+II: As needed, clean the device with a soft cloth dampened with warm water and a
mild detergent solution. Gently rub the soiled area until clean. Use a soft cloth to dry the device. Do
not use abrasive cleaners, alcohol or cleaning solutions which contain alcohol. Do not immerse in water
or other liquids. Care should be taken to prevent water or cleaning solution from running into or onto
the screen, connector openings or crevices.
As needed, clean the display window using a soft, lint free cloth sprayed with an alcohol free glass
cleaner. Do not use paper towels as they may scratch the surface.
Cuffs.
Cleaning CritterCuffs: Clean cuffs with a damp cloth or hand wash in warm water with mild detergent
or soap; do not allow water to get into the cuff tube. Pat cuff dry initially on a towel, and air dry until
fully dry and ready for use.
The cuff extension hoses may be cleaned with a soft cloth dampened with germicidal solution.
SpO2 Sensors.
As needed, the sensor may be surface cleaned. Remove the cable from the unit. Use a soft cloth
moistened in water and a mild soap solution and then wipe it with a 70% isopropyl alcohol pad. Allow
the sensor to dry prior to placing it on a patient.
The SpO2 cable may be cleaned using a soft cloth dampened with a germicidal solution.
Temperature Probes/Extension Cable.
Clean with a soft cloth dampened with a mild soap solution and/or a germicidal solution, as needed.
Do not autoclave.
Battery Replacement.
petMAP+II is configured with a AC/DC adapter and 4 AA NiMH rechargeable batteries. The device can
operate from charged batteries (the approximate remaining battery life is displayed in an icon at the top
of the display) or from line power using the AC/DC adapter. When the AC/DC adapter is plugged in, the
device charges the batteries at the same time as supplying power for its operation.
To replace the batteries, follow these steps:
1) Unplug the petMAP+II AC/DC adapter.
2) With the unit powered OFF, simultaneously press the battery cover latch while pressing down
on the cover near the latch. Slide the cover away from the unit.
3) Remove the batteries.
4) Noting the polarity, insert the replacement batteries.
5) Slide the cover back into place, confirming that the latch has engaged.