Pfaff 1080S User Manual

94 GB
This time you should notice a considerable resist-
ance and much more bending of the needle. If
you do not feel any resistance, this means that
the machine has not been threaded correctly.
Repeat the threading procedure.
Using the needle threader
Bring the needle to the top position by turning the
handwheel anti-clockwise.
1. Hook the thread into the threading hook, as
shown in the picture.
2. Hold the end of the thread firmly and lower the
lever of the needle threader.
3. Turn the lever as far as it goes.
4. Draw the thread under the tongue of the nee-
dle threader and then upwards.
5. Turn back the lever. The needle will be thread
automatically.
6. Release the lever and pull the thread away.
Note: The machine must be set to straight
stitch for threading with the needle threader.
1
2
3
5
6
4
Picking up the lower thread
1. Raise the presser foot lifter.
2. Hold the upper thread with your left hand and
turn the handwheel anti-clockwise so that the
needle is brought into the lowest position and
then into the highest position.
Note: You can quickly pick up the lower
thread if you briefly activate and then release
the reverse switch with the machine set to
straight stitch. The sewing machine will make a
downward and then upward movement and
stop with the needle raised. It is a typical fea-
ture of this computerised sewing machine that it
always stops with the needle up.
3. Pull slightly at the upper thread. The lower
thread will come up through the opening in the
needle plate.
4. Draw out both threads approx. 15 cm and lay
both threads backwards under the presser foot.
1
2
3 4
113223_Naehmaschine_Pfaff_Content_FR.indd 94 02.02.15 10:00

Pfaff 1080S Specifications

General

Brand	Pfaff
Model	1080S
Category	Sewing Machine
Language	English