95 GB
Fabric, thread and
needle table
The selection of the correct needle and the right thread depends on the fabric to be sewn. The following
table is a practical aid for the selection of needles and threads. Consult the table before you start sewing.
Ensure that you use the same type of thread and thread thickness for the top and bottom threads.
FABRIC THREAD NEEDLES
The fabrics listed below can consist of
cotton, linen. silk, wool, synthetic fabric,
viscose or mixed fibres. They are listed as
examples of the corresponding weight
classes. TYPE THICKNESS
Light
Batiste
Chiffon
Crêpe
Cotton-Polyester 100 %
Polyester
* mercerized no. 60*
2020
red shank
11/80
orange band
Medium
weight
Corduroy, / Flannel
Gabardine
Gingham / Linen
Muslin
Wool crepe
Cotton-Polyester 100 %
Polyester
* mercerized no. 50*
nylon
2020
red shank
14/90
blue band
Heavy
Bonded wovens
Canvas
Coat fabric / denim
Duck / canvas
Cotton-Polyester 100 %
Polyester
* mercerized no. 40*
* reinforced thread
2020
red shank
16/100
violet band
18/110
yellow band
Knitted
fabrics
Concealed knitted fabric
Double knitted fabric
Jersey / tricot
Cotton-Polyester
Polyester
Nylon
2045
yellow shaft
11/80
orange band
14/90
blue band
16/100
violet band
Changing the needle
Disconnect the machine from
the power supply by remov-
ing the plug from the socket
socket.
1. Bring the needle to the highest position by
turning the handwheel anticlockwise.
2. Loosen the needle clamp screw by turning
anti-clockwise.
3. Remove the needle by pulling it downwards.
4. Insert the new needle in the needle holder with
the flat side towards the back.
5. Push up the needle as far as it will go.
6. Tighten the needle clamp screw with the screw-
driver included in the delivery.
Note: Pull firmly but not too hard.
Tip: It is easier to change the needle if you put
a piece of fabric under the presser foot and
lower the presser foot. This prevents the needle
from falling into the needle plate hole.
113223_Naehmaschine_Pfaff_Content_FR.indd 95 02.02.15 10:00