4.
Test-Running
the
Machine
Before you test-run the machine, carefully remove the rust preventative.
After
the
machine
has
been
lubricated
as
instructed
above,
test-run
the
unthread
ma
chine with a
piece
of fabric
under
the
presser
foot.
Before you plug the machine
In,
make sure that the voltage indicated on the rating plate
of the motor is within the tension range marked on the electric meter.
Also, make sure the machine pulley rotates in the proper direction, i. e. toward you. If
it
does
not, simply
exchange
the two wires at the motor terminals.
R
7685
Fig.
9
11
To Next Page
Loading...
Need help?
General
