Pfaff 441-O - Page 12

8.8 Turn eccentric bushing 5 located under feed rock shaft crank 4 until the feed dog is
in contact with the gauge throughout its entire length (Fig. 8.0.2); the feed dog now
protrudes 1.1 mm from the needle plate surface.
8.9 inthis position, tighten clamp screws 1 and 3, making sure that the feed dog is still centered
in its slots.
8.10 Check this adjustment (see "Correctsetting").
8.11
Raise the presser bar lifter and remove the gauge from under the presser foot.
10
From the library of: Superior Sewing Machine & Supply LLC