Need help?Do you have a question about the Pfaff 571 and is the answer not in the manual?
General| Brand | Pfaff |
|---|---|
| Model | 571 |
| Category | Sewing Machine |
| Language | English |
Adherence to European regulations, statutory requirements, and environmental protection rules.
Guidelines for safe operation by trained personnel, manual adherence, and safety device usage.
Safety obligations for operating and specialist personnel.
Identification of hazards like needle injury, tipping, and moving parts.
Site preparation and general installation procedures.
Procedure for setting the correct height of the sewing machine table.
Steps for setting the correct tension on the V-belt.
Steps for attaching the flange motor to the machine.
Procedure for installing and tensioning the toothed belt.
Wiring instructions for the safety switch.
Procedure for grounding the machine for safety.
Final checks before operating the machine.
Step-by-step guide for inserting needles into models 571 and 591.
Specific instructions for inserting needles into model 574.
Procedure for winding the bobbin thread and setting primary tension.
How to thread the bobbin case and adjust its thread tension.
Threading the needle and regulating tension on models 571 and 591.
Threading the needle and regulating tension on model 574.
Procedure for adjusting the stitch length setting.
Procedure for applying oil to the hook and hook gib.
Verifying and setting the correct air pressure for the machine.
General adjustments for the fundamental machine operation.
Aligning the needle in the sewing direction for models 571 and 591.
Aligning the needle in the sewing direction for model 574.
Detailed adjustments for needle rise, hook clearance, height, and guard on 571.
Detailed adjustments for needle rise, hook clearance, height, and guard on 574.
Detailed adjustments for needle rise, hook clearance, height, and guard on 591.
Adjusting the needle's lateral position for model 571.
Adjusting the needle's lateral position for model 574.
Adjusting the needle's lateral position for model 591.
Setting the correct height for the feed wheel on model 571.
Setting the correct height for the feed wheel on model 574.
Setting the correct height for the feed wheel on model 591.
Adjusting the eccentric mechanism for stitch length control.
Setting the clearance between the roller presser and feed wheel.
Procedures for adjusting the roller presser's position and pressure.
Synchronizing the movements of the roller presser and feed wheel.
Setting the correct pressure for the roller presser.
Setting various machine parameters via the control panel.
To Next Page
