Pfaff creative 1472

Embroidery stitch
programs
Multi-colour embroidery
Thesemulti colourembroiderypossibilitiessetno
limits
to your
imagination. Carried
out
with great
devotion
to
detail, colour and decorative etfects,
multicolour embroidery gives your
clothes
the
stamp of your
personality
The following pages
are intended
as
an inspira
tion for ornamentation of dresses, blouses and
other garments with embroidery motifs made on
your Pfaff Creative.
Transfer the pattern onto the face side of the
fabric with tracing paper
Always place two sheets of tissue paper
under the
material before
you
start sewing.
prog
-
f
(1j
L
06 62
65 77
j
—3+
2A
H
Sewing thread: Embroidery or darning
thread
Motif 1 is made up
of
the
patterns enumerated
above.
First workstep:
stems
•
Program 06
• Change the
stitch length
to 25
mm.
•
Follow the traced hnes
with
a
program
06
seam.
Second
workstep: leaves
•
Program 62
• Change the stitch
width
to
4.0 mm.
• Change the
pattern length
to
25
• Push the “single
pattern”
key.
• Needle in
down position.
•
Sew the leaf slightly curved,
starting
at
the
stem. Leave the needle down
in the fabric, turn
the fabric
through 180° and sew the pattern
backwards
In
this way,
all
leaves can be
sewn
larger or
smaller.
Third workstep: half
flower
• Program
65
• Stitch
width
5.0 mm.
•
Pattern length:
20
• Push
the
“single
pattern” key.
•
The
tio
of
the pattern
should contact the
stem.
Fourth workstep: flowers
• Program:
62
• Stitch width: 4.5 mm
• Pattern length:
20.
• Push the “single pattern” key
• Sew the petals, including those of the half
flower
Fifth workstep: flower centre
(dot>
•
Programm
77
• Stitch width: 50mm
• Push the “single pattern” key.
• Sew the
flower centres
(dots>.
First
workstep:
centre
motif
• Select
program
64.
• Sew
the
programmed
stitch
pattern.
First
workstep:
centre
motif
•
Select
program
50.
•
Sew the
programmed
stitch
pattern.
Second
workstep:
• Select
program
65 and
change
zigzag width
to
4-5
mm.
•
Sew the
programmed
stitch
pattern
along
both
sides of
the
centre
motif
Third
workstep:
side
motifs
• Enter
program
87.
• Sew
the
programmed
stitch
pattern
on
both
sides
along
the previously
sewn motif.
105
°,
ER
ER
ER
ER
F
Border
1
consists
of the
following
programs:
Centre
motif:
64
Side
motif:
39
Second
workstep:
side
motifs
•
Select
program
39.
• Sew
the
programmed
stitch
pattern
along
both
sides of
the
centre motif.
The
second
side
motif
can
be sewn
without
turning
the fabric
by
pushing
the
“pattern
mirror”
key.
Border
2
consists
of
the following
programs
506587