A
B
C
D
2:12
Threading your creative 2124
Switch off the main switch.
Raise the presser foot lifter. Place the thread on
the spool pin and fi t a spool cap either the same
size or slightly larger.
Using both hands, pull the thread into thread
guide A from the front. Place the thread from
right to left into the pretension guide B.
Now pass it through the left threading slot
downwards through the right-hand side of the
tension disk. Pull the thread around the stop C
and into the right threading slot and upwards
to the take-up lever. The thread must be pulled
into the take-up lever from left to right. Pass the
thread downwards in the right-hand threading
slot.
Pull the thread from the side behind one of the
two thread guides D.
To Next Page
Loading...
