Embroidery
3:15
Get started to embroider
1. Attach the embroidery foot and thread the machine.
2. Attach the embroidery unit and put the presser foot in the
up position. Turn on your machine.
3. The machine prompts you to press the hoop selection
button so that the machine can calibrate.
4. Insert your embroidery creative smart card and choose a
design. The design number will be shown in the window.
The machine will choose the smallest hoop for that design.
Attach the hoop with the hooped fabric to the embroidery
unit. If the hoop on the window does not match the hoop
you have inserted, your machine will not embroider. Touch
the hoop selection button to change the hoop.
5. Thread your machine with color no. 1. (Check your embroi-
dery booklet for more info on the colors).
6. Press the reverse sewing button for a a few seconds to start
your embroidery. The machine will now start to test the
hoop and then tell you to place the presser foot in darn-
ing position. Lower the presser foot lifter slowly and push it
to the rear until it engages in the darning position. When
the presser foot is in the darning position press the reverse
button again and the machine will begin to sew. After a few
stitches the machine will stop in order for you to cut the
thread tail. The cut symbol will fl ash on your window. Cut
the thread and press the reverse button to continue embroi-
dering.
7. When the machine has sewn the fi rst color it will stop and
the no. 2 will fl ash. Change the top thread to no. 2 and con-
tinue to embroider. Repeat this for all the colors.
8. When you have fi nished the last color the machine will
return to the beginning of the design and color no. 1, will
be fl ashing in the window. Remove the hoop from the
embroidery unit and cut the thread ends.
9. Press the parking position button and turn off the machine.
Put the embroidery arm in the packing position and remove
the embroidery unit.
To Next Page
Loading...
