2.
3.
1.
S
T
Embroidery
3:3
Embroidery box overview
The embroidery unit will be delivered together
with four clips, the embroidery foot, the hoop
(225x140), the 300 s- creative smart card and
the booklet.
Attaching the embroidery foot
1. Remove the standard presser foot. Care-
fully loosen the screw (S) until the cross-
hole (T) is accessible.
2. Squeeze the embroidery foot gently
together and guide the pin of the foot into
the cross hole of the presser foot holder as
far as it will go.
3. Tighten the screw (S).
To remove the embroidery foot loosen the screw
(S), squeeze the embroidery foot together and
pull it out to the right. Tighten the screw (S).
To Next Page
Loading...
