3:12
Start/stop: reverse button
In the embroidery mode the reverse sewing
button (108)is a start/stop button. Use the
button when you want to start your embroidery
and when you want to stop. Keep the button
depressed in order to start the embroidery.
Note: You can also use the foot control when
embroidering.
Design width
The width of a design will be shown in the
window in mm (A). You can change the design
width by pressing the + and - buttons (86). The
design can be scaled between 75% to 125%.
Design length
The length of a design will be shown in the
window in mm (B). You can change the design
length by pressing the + and - buttons (87). The
design can be scaled between 75% to 125%.
Thread tension
When loading a design the thread tension will
be set to a predefi ned value (C). If you want to
change the thread tension use the + and - but-
tons (88) to increase or decrease the tension.
To Next Page
Loading...
