Pfaff hobby 1142 - Adjustment of the Presser Bar Height and Alignment

(D)
6mm
(A)
(B)
(F)
(G)
(C)
(E)
104 72 62-26 17
Adjustment of the presser bar height and alignment
Check
When the presser foot (A) is raised, the distance between the zigzag foot (A) and stitch plate (B) should be 6.0
mm.
Adjustment
• Remove the face cover.
• Raise the zigzag foot.
• Pass the allen key (C) through the hole (D) of the supporter.
• Loosen the hexagon socket screw (E).
• Adjust the distance between the zigzag foot (A) and stitch plate (B).
• Tighten the hexagon socket screw (E).
• Check if the pesser foot is paralleled with the feed dog (F) as shown below (G).
If not, loosen the hexagon socket screw (E), and adjust the direction.
• Attach the face cover.