Pfaff powerline 2235 - Control Cam to Roller Lever Clearance (Resting Position)

24
Adjustment
1.06.02 Control cam to roller lever clearance (resting position)
Requirement
When the thread trimmer is in its resting position (balance wheel position 270°) there
should be a clearance of 0.1 mm between the roller lever 5 and the outside edge of cont-
rol cam 1.
Adjust control cam ● 1 (screw 2) together with retaining collar 3 (screw 4) in accordance
with the requirement.
1
2
3
5
4
0,1 mm
Fig. 1 - 18