27
Adjustment
1.06.05 Manual cutting test
Requirement
Both the needle and the bobbin thread should be cut neatly.
Bring thread catcher ● 1 by hand to its front position.
Take a double thread and place it into the catcher slot. ●
Carry out a manual cutting test. ●
If the thread is not cut in accordance with the ● requirement, adjust the knife pressure as
described in Chapter 1.06.04 Knife pressure.
Fig. 1 - 21
1
Consult the instruction manual for the drive for a description of the parameter
settings and a list of the parameters.
To Next Page
Loading...
