9
Attaching the Y belt
Step 1: Loop the belt around the pulley on the motor box
with the teeth towards the pulley.
See fi gure 2-12
Step 2: Pull the belt towards the idler pulley at the back of
the carriage. See fi gure 2-13
Step 3: Loop the belt around the idler pulley with the
teeth towards the pulley.
Step 4: Attach the metal part to the carriage bracket.
See fi gure 2-14 and fi gure 2-15
Step 5: Once you have the belt attached to the fi xed
position of the metal part and Connect the eye bolt to the
opposite end from the fi xed side. Place the threaded part
about half way in so that later if need you can make the
belt tighter or looser depending on your needs. Place the
other end of the belt into the eye of the eye bolt pull the belt
tight and clamp in place. Now to make adjustments to the
tightness of the Y belt you can adjust the eye bolt to pull it
tighter or looser depending on your needs.
See fi gure 2-14 and fi gure 2-16
Figure 2-16
Figure 2-15
Figure 2-14
Figure 2-13
Figure 2-12
To Next Page
Loading...
