24
Zippers and piping
Set the pattern selector dial to " ".
Turn stitch width dial to "0".
Set stitch length control between "1" - "4".
Change to zipper foot (1).
The zipper foot can be attached right (2) or left (3) depending on
which side of the foot you are going to sew.
To sew past the zipper pull, lower the needle into the fabric, raise the
presser foot and push the zipper pull behind the presser foot. Lower
the foot and continue to sew.
It is also possible to sew in a length of cord, into a bias strip to form
a welt (4).
To Next Page
Loading...
