PFISTERER CONNEX cable connector Size 3 and 3/S Assembly / Installation 23
Only for flexible cables:
a) Push two crimping sleeves over conductor.
b) Compress crimping sleeves with hydraulic high-
pressure press.
c) Remove longitudinal burs from crimping sleeves.
d) Cut off conductor to length of 85 mm.
e)
Debur end of conductor and apply protective wrapping.
f) Continue with step No. 42.
41. Apply protective wrapping to end of the conductor.
42. Bevel insulation with bevel cutter.
43. Clean insulation.
ATTENTION!
Clean insulation only from the end of the cable in the
direction of the jacket cut.
Do not touch the remaining easy strip conducting
layer. It may become discolored when coming into
contact with the cable cleaner contaminating the
insulation.
To Next Page
Loading...
