PFT G 54 E - Mixing Tube Spare Parts List

PFT G 54 E Operating Instructions 09/2006
Knauf PFT GmbH & Co.KG
39
Mixing tube spare parts list
Pos. Qty Item no. Description
1 1 20 10 06 50 Mixing shaft G 4/G 5 with exchangeable flange RAL 2004
2 1 20 10 09 00 Tilt flange gasket G 4, sponge rubber, 20 x 15 x 750
3 1 20 10 10 10 Splint D 4.5 with ring
4 1 20 10 12 02 Motor flange pin, zinc-plated
5 1 00 01 05 45 TWISTER stator D5-2.5
6 1 00 02 13 99 Rotor D5-2.5 L
7 1 20 11 87 80 Tie rods, M16 x 360, zinc-pl., 1 set = 2 x
8 1 20 10 42 15 Suction flange f. D pump w. O-ring LA 200
9 1 20 10 42 30 O-ring for suction flange D 117 x 5
10 1 20 10 42 14 D pump suction flange (for O-ring) LA = 200 mm
11 2 20 20 11 00 Geka coupling, 1" internal thread
12 3 20 20 17 00 Geka coupling gasket
13 1 20 20 16 50 Geka coupling blind plug
14 1 20 20 03 30 Reducer coupling, 35V-25V part LW24
15 1 00 08 08 58 Mortar pressure gauge G 5 35 mm
16 1 00 08 15 52 Gauge 0-100 bar filled with glycerin 1/2" with attached joint VA
17 1 20 20 07 90 Coupling 35M part 1, 1/4" internal thread with gasket
18 1 00 00 17 92 Double nipple, 1 1/4" x 60, no. 23, zinc-plated
19 1 00 04 16 64 D pump pressure flange G 4, zinc-pl., 1 1/4" internal thread
20 4 20 20 99 21 Nut, M16, DIN 6331, zinc-plated
21 4 20 20 99 20 Hex nut, M16, DIN 934, zinc-plated
22 1 20 10 35 10 Mixing shaft G 4/G 5, armoured, RAL 2004