4. System Installation and Disassembly
Page 21 of
2. Position the device over the installation holes in the
interface plate or aircraft floor.
3. Secure the stabilizer with four screws.
4.3.3 Installing the System Frame on the Stabilizer
• Make sure that the installation area is free from obstruction by objects.
• The lenses protrude from the bottom of the system frame. When placing the system on
the ground/into the stabilizer, take extra care that the lenses do not make contact with
any objects. Where possible, the lens covers should remain attached to the cameras until
it is necessary to remove them. This avoids any damage to the optics, or contamination
from dust.
• Although the system frame is light enough for installation by a single person, always
install with two people to minimize the potential of an accident.
• Before installing the system frame into the stabilizer, make sure that the stabilizer
interface plate is clear of all cables before lowering the system frame onto the stabilizer.
• Before installing the system frame into a SOMAG GSM 4000 stabilizer, you must install
the adapter plate and secure it with 3 x M8-20 screws, as shown in the following figure:
To Next Page
Loading...