4. System Installation and Disassembly
Page 22 of
To install the system frame:
1. Carefully lower the system frame into the center cavity while making sure that there is enough vertical
space between the camera lenses and the aircraft optical glass hatch.
For open air camera hatches, make sure the camera lenses do not protrude beyond the
aircraft skin.
To secure the system frame to the stabilizer:
1. Fasten the system frame to the stabilizer using the four M6*16 screws provided.
2. Secure the screws using a maximum torque of 6 Nm.
4.3.4 Installing the Pilot Monitor
1. Mount the pilot monitor. A suggested method of
mounting is shown on the right.
To Next Page
Loading...