5. Recommended Flight Operation Procedure
Page 36 of
8. Verify that the Hardware trigger check box is selected.
9. In the Sensors window, click the camera name (1).
10. In the Tools window, click
Trigger Capture (2) and verify
image and GPS data.
11. Close the
Camera window (3).
5.2 In Flight
5.2.1 Check Images
1. After receiving pilot permission, take images to adjust camera parameters.
5.2.2 Line Procedure
1. 3 green lights - verify.
2. Images taken - monitor.
3. Missing images - note.
4. Next line - select at the end of the line.
5. Pilot - engine, fuel, flight parameters.
5.2.3 End of Mission
1. iX Flight - exit project.
2. Sensor handler - Program > Exit.
3. iX Capture - exit.
4. Windows - leave on till after landing.
5.3 After Landing
Before engine shut down:
1. Wait two minutes while standing with engine on.
2. GPS recording - uncheck.
3. iX Controller - off.
4. Microsoft Windows - shutdown.
5. iX Controller CONTROLLER circuit breaker - verify pulled out.
6. iX Controller CAMERA circuit breaker - verify pulled out.
7. SOMAG stabilizer POWER SWITCH - verify set to OFF.
To Next Page
Loading...