XF Camera System | Capture Modes
24
Single capture
One image will be captured when fully pressing the shutter
release button. Holding the button down will NOT result in
additional captures.
Continuous capture
The camera will capture images continuously to the fastest
possible frame rate with the release button held down.
Vibration Reduction (with mirror lock up)
The mirror is locked up for reduced vibration and the shutter is
released after a delay of 4 seconds (default). The delay can be
adjusted between 0.5-8 seconds by accessing the XF [Camera
Operation>Vibration delay] or from the XF Menu on the IQ
back. [Drive>Vibration Delay]
Exposure Bracketing
The camera will capture 3 shots (by default) in succession: one
1-stop under, one at the correct exposure and one 1-stop over.
Dierent EV values can be selected and three steps are of-
fered: 1, 1/2 and 1/3 EV, with the option for 2, 3, 4 or 5 captures.
Bracketing is accessed by tapping the Drive icon on the XF
top screen, or from the XF menu on the IQ [Drive>Exposure
Bracketing]
Exposure Mode
The default setting from the factory is Manual (M). However
there are 4 exposure modes available: Manual (M), Aperture
Pri-ority (Av), Shutter Priority (Tv), and Program (P). In Classic
screen layout, the Exposure Mode can be changed by tapping
the icon on the top touch screen, followed by then toggling the
rear dial or side dial.
To Next Page
Loading...
Need help?
General
