Need help?Do you have a question about the PhaseOne iXM-GS120 and is the answer not in the manual?
General| Sensor Type | CMOS |
|---|---|
| Pixel Size | 4.6 µm |
| Lens Mount | Phase One XF |
| Battery Life | Approx. 300 shots |
| ISO Range | 100 - 12, 800 |
| Shutter Speed | 60 seconds |
| Lens Compatibility | Phase One |
| Storage Media | CFexpress |
| Connectivity | USB 3.0 |
| Weight | 1.5 kg |
| Operating Temperature | -10° to 45° C / 14° to 113° F |
Defines the operational aspects covered within the iXM-GS120 operation manual.
Lists related documents and resources pertinent to the iXM-GS120 camera system.
Provides definitions for key technical terms and abbreviations used throughout the manual.
Details the signals and hardware pulses that govern the camera's exposure sequence.
Explains the black reference process for sensor noise reduction and image quality.
Describes how to initiate black reference sequences using software controls.
Illustrates the four primary electrical interface signals controlling the camera.
Provides pinout details and connection instructions for the camera's power cable.
Details the control cable's pinout, signal names, and voltage parameters.
Step-by-step guide for securely attaching an RSM lens onto the camera interface.
Instructions on how to safely remove an RSM lens from the iXM camera.
Procedure for properly attaching an RS lens assembly to the camera's adaptor.
Steps to safely detach an RS lens assembly from the iXM-RS camera unit.
Guide for mounting the iXM-GS120 camera to a pod using four M4 screws.
Instructions for connecting the control cable to the camera and external device.
Procedure for connecting the camera to the aircraft's power bus.
Steps to connect the camera to a PC via USB 3.1 for data transfer.
How to daisy-chain multiple cameras for simultaneous image capture.
Guide for connecting an HDMI cable to the camera for video display.
Overview of using XQD/CFexpress memory cards for image storage.
Instructions for inserting and removing memory cards from the camera slot.
Procedure for formatting memory cards using iX Capture for optimal use.
Using iX Capture to view a live video feed from the iXM-GS120 camera.
Configuring the camera's HDMI output for full HD video display with or without overlay.
Adjusting key exposure parameters such as shutter speed, ISO, and aperture.
Configuring the camera's internal date and time settings.
Adjusting the orientation of captured images based on camera positioning.
Configuring GPS settings for time synchronization and receiver details.
Defining the time delay before the camera enters low power mode.
Resetting camera settings back to their original factory defaults.
Guide to installing the Phase One Firmware Updater software on a PC.
Procedure for updating the iXM-GS120 camera's firmware to the latest version.
How to verify the currently installed firmware version on the camera.
Steps to restore the camera's firmware to its original factory version.
Explanation of Operation LED states indicating camera temperature status.
To Next Page
