PhaseOne iXM-GS120 - Connecting the iXM-GS120 Camera; Attaching Camera to a Pod; Connecting a Control Cable; Connecting the Power Cable

iXM-GS120 Operation Guide
7. Connecting the Camera
Page 19 of
32
7 Connecting the Camera
7.1 Attaching the Camera (iXM-GS120) to a Pod
1. Attach the iXM-GS120 camera to a pod using four M4 screws.
7.2 Connecting a Control Cable
1. Connect the control cable LEMO connector to camera left LEMO (data) port (near the USB port).
2. Connect the other end of the control cable to your external device.
7.3 Connecting the Power Cable
To connect the camera to the aircraft power bus:
1. Connect the power cable LEMO connector to camera power port.
2. Connect the other end of the power cable to the aircraft power bus.
Caution
The iXM-GS120 camera must be powered by a limited fused power source only, up to 2A single fault condition.
Note
Do not insert screws deeper than 6 mm into the threaded holes on the front of the camera.
Note
• The two data ports (left and center LEMO ports) are not interchangeable.
• If the camera is being used with a Phase One system, use a control cable with LEMO connectors at both ends, and connect
the other end to the iX Controller i/O port.