PhaseOne iXM-GS120 - Formatting a Memory Card

iXM-GS120 Operation Guide
9. Storing Images
Page 26 of
32
4. Place the memory card cover in position and secure the cover with the memory card slot cover screw. Tighten the screw to
torque 15 cNm.
To eject the memory card:
Caution
Before ejecting the memory card, to prevent data corruption, make sure the camera is in LOW POWER MODE as follows:
1. Run iX Capture.
2. Click SETTINGS.
3. Click the required camera tab
.
4. Click SERVICE.
5. Set LOW POWER MODE to Immediately.
1. Momentarily push the memory card then release it. The memory card is ejected.
9.1.2 Formatting a Memory Card
To format a memory card:
1. Run iX Capture.
2. Click SETTINGS.
3. Click the required camera tab
.
4. Click FILE.
5. Set STORAGE to LOCAL.
Note
Before capturing images for the first time, verify that local storage is enabled as follows:
1. Run iX Capture.
2. Click SETTINGS.
3. Click the required camera tab
.
4. Click SERVICE.
5. Click FORMAT CARD and click CONTINUE.